5 Configurations on Web Interface
UC100-1
V
1S1O User Manual
Copyright©2011-2016 Dinstar
44
Netmask
The netmask of the static route, default: 255.255.255.0
Gateway
The IP address of the outbound gateway of the static route
Interface
The outbound interface of the static route, namely WAN port or LAN port
Status
The static route is enabled or disabled
5.4.10
UPnP Client
UC100-1G1S1O can serve as an UPnP client. When UC100-1G1S1O is deployed at a
local-area network and its outbound router supports the UPnP function, you can enable the
UPnP function on the
Network
UPnP
Client interface of the UC100-1G1S1O device, and
thus its outbound router is notified by the UPnP protocol to carry out port mapping.
For example, the public IP address of outbound router is 172.16.20.12, and the external port
configured on UC100-1G1S1O is 8080. When UPnP HTTP is enabled, the router will create a
port mapping from external HTTP port 8080 to intranet HTTP port 80, and thus clients in
public network can visit the UC100-1G1S1O gateway which is in local-area network through
entering 72.16.20.12:8080.
Figure 5-39 UPnP Client
5.4.11
VPN Client
VPN
（
Virtual Private Network
）
is a network technology that creates a secure remote network
connection over a public network through encrypted tunnel and conversion of data’s
destination address. UC100-1G1S1O can serve as a VPN client to connect with VPN server.
UC100-1G1S1O supports the following VPN protocols:
Layer 2 Tunneling Protocol (L2TP)
is a protocol used to package data of PPP link layer and
transmit the data between two sites over the Internet through a tunnel.