2 Installation
SBC3000 Session Border Controller
Copyright©2011-2018 Dinstar
9
Connect SBC3000 to Network
SBC3000 has two network ports on each MCU (Main Control Unit), namely GE1 and GE0. By default, the GE1
port is used to log in the SBC3000 device.
Both GE1 and GE0 can be used to carry out management on SBC3000, but only GE1 is put in use generally.
How to make RJ45 Network Cable
Step1.
Prepare a twisted-pair cable with a length of at least 0.6 meters, and then remove the shuck of the network
cable;
Step2.
Sequence the wires of the cable according to EIA
／
TIA 568B Standard (as shown in the following figure);
Wire sequence of 568B: white & orange, orange, white & green, blue, white & blue, green, white & brown, brown.
Step3.
Put the wires into the PINs of a RJ45 joint according to the abovementioned wire sequence of EIA/TIA
568B, and then use a wire crimper to crimp the RJ45 joint.
Step4.
On the other end of the network cable, sequence the wires of the cable according to EIA/TIA 568A
Standard (as shown in the following figure);
Wire sequence of 568A: white & green, green, white & orange, blue, white & blue, orange, white & brown, brown.
Step5.
Put the wires into the PINs of a RJ45 joint according to the abovementioned wire sequence of EIA/TIA
568A, and then use a wire crimper to crimp the RJ45 joint.
Summary of Contents for SBC3000
Page 3: ......
