3 Configurations on Web Interface
SBC300 Session Border Controller
Copyright©2011-2018 Dinstar
11
3
Configurations on Web Interface
3.1
How to Log in Web Interface
Preparations for Login
SBC300 has five network ports, namely the gigabit network ports for services (from GE0 to GE3) and the gigabit
network port for management (Admin). It is advised to connect GE0/GE1/GE2/GE3 to the IP network.
The default IP address of the ‘Admin’ port is 192.168.11.1, while those of GE0, GE1, GE2 and GE3 are 192.168.12.1,
192.168.13.1, 192.168.14.1 and 192.168.15.1 respectively.
First Use
At the first time that the SBC300 device is put in use, please connect the device’s Admin port to a PC by using a
network cable, and then modify the IP address of the PC to make it at the same network segment with of the default
IP address of the Admin port. The format of PC IP address is 192.168.11.XXX, since the default IP of Admin port
is 192.168.11.1
Daily Use
Connect the service port (GE0/GE1/GE2/GE3) of SBC300 to a 1000Mbps or 10/100mbps switch.
If SBC300 is connected to a 1000Mbps switch, the link indicators on the front panel turn green and flash, while the
speed indicators turn yellow.
If SBC300 is connected to a 10/100Mbps switch, the link indicators on the front panel turn green and flash, while
the speed indicators remain dull.
SBC300
Switch
PC
Internet
