DWG2000E/F/G GSM/CDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Technologies Co., Ltd.
11
3. Basic Operation
In this chapter is mainly to introduce basic operation of gateway.
3.1 IVR Navigator
The gateway is embeded IVR system for local maintainance.In each step, if user hears an IVR
message of “setting succeed”, which means that user has finished this step successfully.
However, if user hears a “setting failed” message, please check and redo that step again.
Table 3-1 Feature codes for system setting
Dial numbers
Features
*150*a#
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is static
IP address mode, *150*2# is DHCP mode
*152*a*b*c*d#
Configure IP address, a, b, c, d are the four fields of IP address.
*153*a*b*c*d#
Configure subnet mask. a, b, c, d are the four fields of the subnet
mask
*156*a*b*c*d#
Configure the device gateway, a, b, c, d are the four fields of the
device gateway
*158#
Query the IP address
*111#
Restart device
3.2 Basic Operation
3.2.1 Check IP address
With a Mobile phone call the SIM card number, the gateway will answer and play voice prompt
‘dial the extension number’, press *158# on mobile phone then local IP address will be
reported by gateway automatically.
3.2.2 Restore factory setting via IVR
With a Mobile phone call the SIM card number, the gateway will answer and play voice prompt
‘dial the extension number’, press *166*000000# on mobile phone then the user will hear
‘setting succeed’. Reboot gateway to take setting effective.
3.2.3 Restore default IP and password
Press RST button about 3 seconds then reboot gateway. The IP address, username and
password will be back to factory default.
3.2.4 Restore factory setting
Press RST button about 7 seconds then reboot gateway then it will restore to factory setting.
