32
•
Rotate the ENCODER - A (E1) knob until both the displays read
dEF no
(see figure).
E1
•
Rotate the ENCODER - V knob (E2) until the PARAMETERS
DISPLAY - V screen (D2) reads
YES
.
D2
E2
•
Hold the SAVE “MEM” key (T2) down for at least
2
consecu-
tive seconds.
T2
T ≥ 2 s
•
The program in use has now been completed successfully. To
confirmation the above, the control panel of the welder performs
a short operation of MACHINE CHECK (all of the LED stay lit
simultaneously so as to verify their actual operation), the gen-
erator itself starts, having memorised the new settings and is
again ready to weld.
3 - PRE-SETTING
Before welding it is possible to set the following parameters:
D1
T1
E1
WELDING CURRENT
Example: WELDING CURRENT
Press the PARAMETER SELECTION - A key (T1) until the LED
that corresponds to the WELDING CURRENT switches on. Turn
the ENCODER - A knob (E1) to change the value shown on the
PARAMETER DISPLAY - A screen (D1).
4 - WELDING
During the welding the display shows:
•
PARAMETER DISPLAY screen - A (D1)
D1
WELDING CURRENT
- WELDING CURRENT (
): the measured value of the current
of what is being welded.
•
PARAMETER DISPLAY screen - V (D2)
D2
WELDING VOLTAGE
- WELDING VOLTAGE (
): the measured value of the voltage
of what is being welded.
5 - HOLD
This function automatically starts itself at the conclusion of eve-
ry welding operation welding and it is indicated to the operator by
means of a flashing light of the HOLD FUNCTION LED for a spe-
cific amount of time. Once the welding has been terminated, for
about
15
seconds, both the DISPLAYS should show the same val-
ues of the parameters during the welding.
In this phase the displays show:
•
PARAMETER DISPLAY screen - A (D1)
D1
WELDING CURRENT
- WELDING CURRENT (
): the last current value measured.
•
PARAMETER DISPLAY screen - V (D2)
D2
WELDING VOLTAGE
- WELDING VOLTAGE (
): the measured value of the last volt-
age of what is being previously welded.
To interrupt the HOLD function and go back to the PRESETTING
phase before
15
seconds have passed, simply turn one of the two
ENCODER (E1-E2) knobs.
