Dinolift 10196, Operating Instructions Manual

Page: 36 / 59

36
Operating instructions • DINO 105TL
5.3. TRANSFERRING THE LIFT
The lift can be transferred by towing or using its own driving device (option).
The lift may only be moved in the transport position. No persons or load are
allowed on the platform during the transportation.
5.3.1. Preparing the lift for transport
During transfer, the lift must always be in the transport position.
Prepare the lift for the transfer as follows:
1. Retract the telescopic boom fully.
2. Lower the boom/platform onto the support on the tow-bar. The limit switch on the
transport support prevents the operation of the support outriggers if the platform is not
down.
3. Close the control centre cover on the work platform.
4. Lift the support outriggers.
Lift first the rear support outriggers (do not damage the rear lights), and then the front
support outriggers (do not damage the jockey wheel).
5. Make sure that the covers are locked.
If you intend to tow the lift:
6. Apply the parking brake.
7. Make sure that the driving device is disconnected.
8. Turn the selector switch to position OFF and disconnect the lift from the power supply.