Start Up
8
ti26
Setup
Setup
When unpacking sprayer for the first time
or after long term storage perform setup
procedure.
Assemble Your Sprayer
1. Connect DP airless hose to fluid
outlet. Use wrench to tighten
securely.
6. Turn pressure control knob all the
way left (counter-clockwise) to
lowest set- ting.
2. Connect other end of hose to gun.
7. After long term storage check
inlet strainer for clogs and debris.
3. Use two wrenches to tighten securely.
If hose is already connected, make
sure connections are tight.
4. Engage trigger lock.
5. Remove tip guard. Be careful tip seal
may fall out when tip guard is
removed.
Strain the Paint
Previously opened paint may contain
dried paint or other debris. To avoid
priming prob- lems and spray tip clogs it is
recommended to strain the paint before
using. Paint strain- ers are available
where paint is sold. Stretch a paint
strainer over a clean pail and pour the
paint through the strainer to capture any
dried paint and debris before spraying.