Dino-Power DP-X3, Operation Manual, Page: 15 / 32

How to Spray
14
How to Spray
Triggering Gun
Pull trigger after starting stroke. Release
trigger before end of stroke. Gun must be
moving when trigger is pulled and
released.
TI2037A
Aiming Gun
Aim center of spray of gun at bottom edge
of previous stroke, overlapping each
stroke by half.
Spray Pattern Quality
A good spray pattern is evenly distributed
as it hits the surface.
•
Spray should be atomized (evenly
dis- tributed, no gaps at edges).
If tails persist when spraying at the highest
spray pressure:
•
Spray tip may be worn. See Tip
and Pressure Selection , page13 .
•
A smaller spray tip may be needed.
•
Material may need to be thinned. If
material needs to be thinned follow
manufacturer’s recommendations.
Clear Tip Clog
In the event that particles or debris clog the
spray tip, this sprayer is designed with a
reversible spray tip that quickly and easily
clears the particles without disassembling the
sprayer.
See
Strain the Paint , page 8 for additional
information.
1. Engage trigger lock. Rotate spray tip to
unclog position. Disengage trigger lock.
Trigger gun at waste area to clearclog.
UNCLOG
NOTE: If spray tip is difficult to rotate when
turning to the unclog position perform,
Pressure Relief Procedure
, page 9, then
turn Prime/Spray valve to spray position and
repeat step 1.
2. Engage trigger lock. Rotate spray tip
back to spray position. Disengage trig-
ger lock and continue spraying.
SPRAY
tails- gaps
at edges
good
spray pattern
pressure
too low