KM-01 Knob Motor User Guide
Package contents
NOTICE BEFORE ASSEMBLY
Assembly instructions
Align and snap together the c-clip to Dino-Lite.
WRONG POSITIONS:
Covering the knob
Slits facing up
Not aligned
Mount the c-clip onto the knob motor.
NOTE:
An extension cable can be made for extending the distance between the knob
motor and the control box with a 0.5mm² x 2C cable and supplied 2 pin circular
DIN connectors. The recommended length of the extension cable should be
within 10 meters.
(Optional) Connect the USB cable to the control box and PC. The KM-01 Left/Right
rotation control can then be controlled by either the control box or the DinoCapture
2.0 software. Additionally, the MicroTouch on the control box can trigger the
DinoCapture 2.0 software to take a picture.
Plug in the power adapter and connect it to the control box.
Connect the knob motor to the control box.
The KM-01 works with a certain range of Dino-Lite. If not certain whether the
Dino-Lite is compatible to the KM-01, please consult your reseller or distributor.
The KM-01 can work alone or work together with PC’s using DinoCapture 2.0
software version 1.4.1 or newer.
Some Dino-Lite models have the ability to lock the knob to prevent it from
scrolling. Please make sure the knob is NOT locked to avoid damage to the knob
motor.
USB 2.0 cable
Short / Long
handscrew
DinoCapture 2.0
CD
Power adapter
Control box
Knob motor
C-clip
Male / Female
2 pin circular
DIN connector
align here
C-clip
A
B
C
P/N:24101K1
Properly mounted
1
2
3
A.
B.
C.
Power adapter
Knob motor
USB 2.0
(Optional)
(User’s computer)
