3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator
E-AF09_02_16.03_EN_U
61
13.3.6 DETERMINATION OF THE TRUCK’S NET WEIGHT BY SUBTRACTING THE PRESET TARE
Premise: This function is available if the input/output weighing mode is enabled.
If a manual tare has manually been set or recalled by selecting a vehicle (see section 7), the indicator automatically subtracts
it from the total weight accumulated,
as long as it is not greater than it, at the end of the axle totalization cycle.
The indicator will print the total weight accumulated (Gross Weight), the manual tare identified with “PT” (Preset Tare) and
the weight difference (Net Weight).
It is possible to choose if the weight difference should be accumulated in the total weight in input or in the total weight in
output.
- To accumulate it in the total input weight, one has to carry out the axle totalization as for the standard input weigh, by
pressing the
F6
key after having entered a tare value(see section 7); the procedure is therefore the same as the input
weighing (see section 13.3.1.2, 13.3.2.2 or 13.3.2.3 depending on the acquisition mode).
- To accumulate the weight difference in the total output weight, one has to carry out the axle totalization as for the standard
input weigh but by pressing the
F7
key after having entered a tare value(see section 7); the procedure will be as for the input
weighing (see section 13.3.1.2, 13.3.2.2 or 13.3.2.3 depending on the acquisition mode) but the weight difference will be
accumulated in output.
If the manual axle totalization mode is set, the display shows the tare value, identified with “PT”, before the weighing
procedure:
3590E
LED display
LCD display
CPWE
[In which:
XXXXXX
is the weight value]
13.3.7 DELETING ALL THE INPUT MEMORY STORAGES
Through the
426
function, combinable with the desired key (
<< F.KEYS >>
step,
TECH.MAN.REF.
), it’s possible to cancel all
the memory storages.
The display shows “
Sure?
”, press
ENTER
to confirm or another key to return in the cycle.
13.4 FUNCTIONS OF THE AUTOMATIC AXLE WEIGHING CYCLE (STATIC OR DYNAMIC)
13.4.1 CANCELLING OF THE CYCLE
During the automatic weighing cycle, one can cancel all by pressing the
F10
key: the display shows
“Sure?”
and “CANCEL
WEIGHING CYCLE?”. Press
ENTER
to confirm or another key to return in the cycle.
1
CUS MAT VEH
PT:
1000kg
XXXXXX
CUS MAT VEH
PT:
1.000kg