DINGLI JCPT2223RTA, Operators Manual With Maintenance Information

Page: 55 / 75

OPERATOR’S MANUAL
with Maintenance Information
Maintenance
48
B-4
Inspect the Tires and Wheels
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Maintaining the tires and wheels in good
condition is essential to safe operation and
good performance. Tire and/or wheel failure
could result in a machine tip-over. Component
damage may also result if problems are not
discovered and repaired in a timely fashion.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
3 Check each lug nut for proper torque.
lug nut torque, dry 600Nm
lug nut torque, lubricated 450Nm
B-5
Check the Oil Level in the Drive Hubs
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Failure to maintain proper drive hub oil levels
may cause the machine to perform poorly and
continued use may cause component
damage.
1 Before draining oil it is mandatory to rotate
the planetary gear reduction in order to
move the oil plug in filling position, then
loosen the oil plug and wait until the
internal pressure is completely released.
2 Remove the plug located and check the oil
level.
⊙
Result: The oil level should be even with the
bottom of the plug hole.
3 If necessary, remove the plug and add oil
until the oil level.
4 Apply pipe thread sealant to the plug(s),
and then install the plug(s) in the drive
hub.
5 Repeat this procedure for each drive hub.