Configuration
INDICATOR DG8000 RevB0
32
CHECKING THE HARDWARE MODULES
Access through the key number 4 of the Setup menu.
This section carries out a check on the hardware parts of the system:
-Display
-Keyboard (it is possible to strike a key and see the corresponding acquired code);
-Jumpers HW (different symbols for closed or opened jumpers)
-RAM CPU (if accessible or not)
-Flash #1 (if accessible or not)
-Flash #2 (if accessible or not)
-EEPROM #1 (if accessible or not)
-EEPROM #2 (if accessible or not);
-Data Transfer (if cartridge is connected or not);
-Clock (date/time)
-A/D chip: values read by the A/D 4 channels;
-Power: voltage Vbat =supply, Vcc = logic tension 5V, V3p3 = logic tension 3.3V, Vlcd =
display contrast tension
-Temp (temperature value)
-Buzzer
-Led
-Printer (if connected or not)
You can move from one step to the subsequent one by pressing ENTER. When the check
is over, go back to the main configuration menu by pressing RESET.
