Configuration
INDICATOR DG8000 RevB0
24
SETTING OF THE BASE PARAMETERS
Access through the key number 2 of the Setup menu.
In this section, all parameters necessary for the correct functioning of the weighing system
are set up. All data contained in this section can be modified by the operator.
The programming mode is the following:
1
Select the parameter using the keys
↑
and
↓
(using the
→
or
←
keys you can move
from one page to the other one at a time).
2
Press ENTER to enter the “modify data/value” mode.
3
Use the
↑
or
↓
keys or the keys to increase the value to set/select the datum/the
desired value.
4
Confirm your choice by pressing the ENTER key
5
Repeat the cycle
6
At the end of the programming phase, keep the
key pressed for 5 seconds to
store the data into the memory.
7
Furthermore, in case of errors, the system gives you the possibility of recalling the
default data set up by the manufacturer. Press this key
, to recall the default
data.
With this key,
you can recall the initial configuration or the last saved data.
8
Go back to the main configuration menu by pressing RESET.
