Dinamica Generale AgriNIR, Operator'S Manual

Page: 49 / 68

Use AgriNIR™ Analyzer Rev. A11
E
NG
L
IS
H
47
6.14 Calibration Updating of AgriNIR™ System
In the second main component selection screen, the AgriNIR™ system offers the following setting
commands :

CALIBRATION CURVES
UPDATING
With this command you can update the
calibration curves of the NIR families (available
on the main screen list) that can be analyzed by
the AgriNIR™ system.
To update the calibrations :
1. insert the USB memory key with the file
comp.a37
containing the new calibration curves;
2. select the ID of the component (see component list in the main screen) where you wish to update
the calibration;
3. press the special key to update the calibration in the internal memory of the AgriNIR™
system.
NOTE.
DO NOT remove the USB memory key until the message of ended calibration is displayed!
If the file
comp.a37
that contains the new
calibration curves IS NOT available on the USB
Key, the error message here shown on the left
appears.