dimtel
dimtel
5.3
Display Panels
5.3.10
8-channel ADC Panel
Figure 14: 8-channel ADC panel
This panel provides readouts of the eight 12-bit ADC channels updated
at 1 Hz. The input signals are low-pass filtered to 1 kHz before sampling.
5.3.11
GPIO Panels
General-purpose I/O control panel in practice consists of two different panels,
one for bit-by-bit GPIO driver and one for the front/back-end driver. Using
the choice buttons on the top of the panel one can select one of the two
drivers.
WARNING: Front/back-end driver sets several I/O pins as out-
puts. Make sure correct hardware is connected to the GPIO port
before selecting this driver! Improper driver selection may cause
damage to the output pins and the connected external devices.
Bit-by-bit control panel, shown in Figure 15 provides individual bit con-
trols for 32 LVTTL signals available on the rear panel. Each bit control in-
cludes output value (0 or 1), direction (In or Out), and the readback. When
the signal is configured for output the readback should reflect the output
value.
31 of 58
