8
www.dimplex.com
Fireplace Installation
generated under certain
abnormal conditions. Do not
partially or fully cover or
obstruct the bottom of this
heater. Bottom of unit must be
a minimum of 356 mm above
the floor or any surface
such as a tabletop to ensure
adequate space for heat
exhaust from the bottom
of the fireplace (Figure 2).
③
With a wall stud finder,
locate the center of the wall
stud, drive a wood screw into the
stud and leave approximately
3 mm exposed threads for the
fireplace to hang on.
④
The second mounting point
should be picked such that it
is farthest (to the left or right)
relative to the first one among the
seven (7) keyholes (A to G shown
in Figure 1) on the fireplace for
wall mounting, these keyholes
are 51 mm apart. For example,
if you plan to use hole B as the
first mounting hole, the second
mounting hole must be G.
Other available combinations are
A-G, C-G, A-F, A-E, A-D and D-G.
⑤
Mark the second mounting
screw location; ensure that it is
level with the first with the help
of the provided bubble level and
the fireplace itself. Screw the
threaded drywall anchor in the
drywall with a Philip’s head
screwdriver until the head is flat
against the wall surface.
Caution should be taken when
using a power tool to install a
threaded drywall anchor as the
drywall may distort, tear or slightly
buckle as a result of over-torque.
⑥
With a Philip’s head screw
driver, screw the drywall anchor
screw into the drywall anchor
already in the wall, leave 3 mm
exposed threads for mounting
the
fireplace.
Figure 2
Heat Exhaust