14
www.dimplex.com
Operation
controls the brightness of the
top accent light that is used to
illuminate the pebbles.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
Main On/Off Switch to Off (“
O
”)
and waiting five (5) minutes
before switching the unit back on.
CAUTION:
If you need to
continuously reset the heater,
disconnect power and call
customer service.
CAUTION:
In order to avoid
a hazard due to inadvertent
resetting of the thermal cutout,
this appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a circuit
that is regularly switched on
and off by the utility.
Remote Operation
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 15 m. It does
not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
The remote is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
!
NOTE:
Before attempting any
operation with the remote,
pull the plastic insulator strip
out from between the remote
casing and battery cover
(Figure 9).
Remote Initialization
Should your remote have difficulty
communicating with the remote
receiver, or should either the
Figure 9
On button
Battery
cover
Plastic
strip
Off button