Dimplex TLC20LX-AU, Instruction Manual, Page: 12 / 16

Operation
Operating Instructions
Dis-
play Func-
tion Description
A -
Power /
Standby
Press Once to turn the product ‘ON’.
Press a second time to p
ss a second time to put the product into ‘STANDBY’.
(When returning from ‘STANDBY’ mode the product will return to previous settings
unless the product has been unplugged, in which case it will reset to factory settings)
B
'FLAME EFFECT' button turns the flame effect ON or OFF independently of the
products other features.
+
Flame
Up
This Button will increase the brightness of the flame effect. There are 5 brightness
settings shown as F1, F2, F3, F4, F5. This button will ONLY increase the brightness
level.
-
Flame
Down
This Button will decrease the brightness of the flame effect. There are 5 brightness
settings shown as F1, F2, F3, F4, F5. This button will ONLY decrease the brightness
level.
Flame
Cycling
This setting is set by pressing the Flame Up button once more after F5. This will
cause the brightness of the flame effect to cycle from F2 to F5 in a continuous loop.
-
Off
This will turn the flame effect off. If the heater is running, the display will activate and
remain active to read the set temperature and show if the product is on LOW HEAT/
HIGH HEAT/COOL BLOW.
C
'HEAT' button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH
HEAT, COOL BLOW and OFF. The heat setting will be indicated by an icon in the
display (see image on page 5).
When the flame effect is 'ON,' the display will turn off after 5 seconds, however if the
heater is being used independently of the fame effect, the low heat or high heat icon
will appear continuously in the display.
Low
Heat
This setting will run the heater at 'LOW HEAT.' This setting will be indicated by the
'LOW HEAT,' icon. To adjust the temperature setting, the Temp Down or Temp Up
buttons described below must be used.
(This icon is
Red
in colour).
High
Heat
This setting will run the heater at 'HIGH HEAT.' This setting will be indicated by the
'HIGH HEAT,' icon. To adjust the temperature setting, the Temp Down or Temp Up
buttons described below must be used.
(This icon is
Red
in colour).
Cool
Blow
This icon in the display indicated 'COOL BLOW.'This setting will be indicated by the
'COOL BLOW,' icon and the letters 'CB' appearing on the display.
(This icon is
Blue
in colour).
-
Off
This switches the heater and blower 'OFF,' and no icon will be displayed. Note that the
blower will run for 5-10 seconds after being turned off, to ensure the product cools
down safely.
D
- Back
Light
Pressing this button will turn ON and OFF the back lighting. There are 4 settings, Sides
only, Top only, all OFF and all ON.
E
- Temp
Down
Press multiple times to lower the heater temperature in 1°C increments. The lowest
temperature that can be set is 18°C.
E
-
Temp Up
Press multiple times to increase the heater temperature in 1°C increments. The
highest temperature that can be set is 30°C.
When High Heat is selected, the letter 'HH' will appear on the display. This means the
heat will remain ON continuously and is not controlled by the thermostat.
12