Operating The Product
Selector Switch 2 (I) Provides 750W heat output
Selector Switch 3 (II) Provides 1500W output with switch 2 also pressed.
Thermostat (T) - see Fig. 3
In order to maintain a certain room temperature, set the controller to ‘max.’. Operate the
appliance at full power until the required room temperature is reached. Set back the thermostatic
controller until the appliance switches off with an audible “click”. This temperature will be kept
almost constant by the thermostatic control switching on and off automatically. Please note
that the appliance can only be switched on when the thermostat setting is higher then the room
temperature.
Remote control - see Fig. 4
The maximum range of use is ~ 5metres.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for correct operation.
Battery Information - see Fig. 4
1. To activate the remote control remove the battery isolation strip, which is used to ensure your
remote control reaches you fully charged.
2. To replace the remote control battery, turn over the remote control, remove the screw, follow
the instruction on the back of the remote to release the battery housing. Slide the battery cover
open. Install Lithium battery in the battery holder. The positive (+) side of the battery faces up.
Close the battery cover and replace the screw
3. Only use CR2025 or CR2032 size of batteries.
Discard leaking batteries
Dispose of batteries in the proper manner according to provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all
the batteries are not replaced at the same time, if disposed of in a fire, or if an attempt is made
to charge a battery not intended to be recharged.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE
HEATER.
Cleaning
Before commencing cleaning, unplug the heater and allow it to cool. For general cleaning use
a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned
carefully with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner
should occasionally be used to clean the outlet grille of the fan heater.
It is possible to clean the inner glass and logset by removing the outer glass panel. To remove
the outer glass, remove the 4 screws holding the grille in position, (see Fig.5), remove the grille
and lift clear the outer glass.
Refit the outer glass in reverse of above.
WARNING: do not operate the product without the grille and outer glass in position as this may
effect the operation of the heater.
Recycling