7
WARNING:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING:
Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING:
Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:
To reduce the risk
of fire, do not store or use gaso-
line or other flammable vapors or
liquids in the vicinity of the heater.
CAUTION:
Clearance for air
circulation beneath the fire-
place insert is provided by two
(2) rubber feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION:
If installing the
fireplace in a carpeted area,
place a one-piece, solid, flat
surface under the fireplace
insert. Ensure that both of the
insert’s feet rest securely on
this surface.
!
NOTE:
The dimensions of
the fireplace are 31 ½ in. (800
mm) wide x 22 ⅜ in. (568 mm)
high x 9 ⅛ in. (232 mm) deep.
The fireplace does not require
any additional venting.
Mantel Installation
Install the fireplace assembly into
the mantel (refer to mantel as-
sembly instructions).
!
IMPORTANT:
If not using
a Dimplex mantel, the fireplace
must be installed in an enclosure
with the following
minimum
inter-
Fireplace Installation
Figure 1
22 ¾”
(578 mm)
31 ¾”
(807 mm)
9 ½”
(241 mm)