6
www.dimplex.com
Fireplace Installation
WARNING:
To reduce the risk of
fire, do not store or use gasoline or
other flammable vapors or liquids in
the vicinity of the heater.
WARNING:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING:
Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING:
Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
!
NOTE:
A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional ap
-
pliances on the same circuit may
exceed the current rating of the
circuit breaker.
Glass Installation
(if applicable)
1. Unpack the firebox and the
front glass.
2.
Remove the glass retaining
bracket from one side of the
firebox. (Figure 1)
3.
Slide the glass into the glass
support track on both the top
and the bottom, until it is fully
inserted.
4. Replace the glass retaining
bracket.
Figure 1