FIGURE 2
REMOTE CONTROL
The fireplace is supplied with a radio frequency remote
control. This remote control has a range of approxi-
mately 50ft. (15.25m), it does not have to be pointed at
the fireplace and can pass through most obstacles
(including walls).
Remote Control Initialization
This procedure is required every time there is a loss of
power to the remote control in the fireplace (i.e. power
failure, breaker tripped, main power switch is turned off)
1. Ensure that power is supplied through main service
panel.
2. Locate manual controls refer to FIGURE 2.
3. Activate main power switch, red indicator lights 1 will
flash.
4. Press button located on the remote control
transmitter (FIGURE 1). This will synchronize the
remote control transmitter and receiver.
Remote Control Usage
The remote control operates the fireplace levels se-
quentially. The level is increased every time the
button on the transmitter is pressed. The fireplace can
be turned off at any point by pressing the button on
the remote control transmitter.
Level 1: The flame effect is turned on and the first red
indicator light flashes momentarily.
Level 2: The flame effect remains on, the heater is
activated to the low heat setting, and the first and sec-
ond red indicator lights flash momentarily.
Level 3: The flame effect remains on, the heater is set
to the high heat setting, and all three red indicator lights
flash momentarily.