Digium, Inc.
Page 21
Chapter 2: Card Installation
Port Identification
Each card consists of four RJ11 ports located on the bracket. Each port
correlates to a single module port (containing either FXO or FXS
modules). The ports are numbered in sequence from one to four. The top
port is Port 1 and the bottom port is Port 4. See Figure 2 on page 22 for
appropriate identification of these ports. The port identification is the
same for all cards in this series.
It is important to identify the type and location of your Analog 410 Series
modules. You will need this information during the Asterisk
configuration.
The ports available for use on the Analog 410 Series cards are continuous.
The cards can accept 4 single modules, for a total of 4 ports. The single
module ports are identified on the card and their corresponding RJ11 ports
are identified below. The RJ11 port available for use will be the port
corresponding to the location of the module on the card. The following
ports correspond to the single module ports as shown in Figure 2 on page
22.
RJ11 Port 1 is used by Single Module Port 1
RJ11 Port 2 is used by Single Module Port 2
RJ11 Port 3 is used by Single Module Port 3
RJ11 Port 4 is used by Single Module Port 4
