Digium, Inc.
Page 30
Chapter 2: Card Installation
The PWR2400B does not connect to any bus inside the computer. It may
be used wherever there is an available PCI-size bracket such as a PCI,
PCI Express, or AGP slot.
Note: The PWR2400B is not intended to supply power to any other
device, it is intended only to be used with UL Listed Digium analog
cards.
5.
Replace the cover to your computer.
6.
Plug all outside phone lines to the FXO (red) ports and connect all
phones to the FXS (green) ports as needed using a patch panel or
punch block. See Table A-1 on page 56 for the pin assignments.
Electrical Shock.
To reduce the risk of injury, damage to the unit or your
equipment, do not attempt to apply power to the unit while the
case is open.Personal injury or damage to the unit could occur
if the modules are touched while powered is applied.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord, e.g.: for
Australia use only line cords complying with ACA Technical
Standard TS008.
Caution.
Only connect regulatory equipment (approved for use in your
specific country) to the telecommunications network voltage
circuit ports.
