5
4.
Installation
Before placing the Unit:
•
Do not to cover PoE Injector or block the airflow to the PoE with any
foreign objects. Keep the PoE Injector away from excessive heat and
humidity and free from vibration and dust.
•
Ensure that the cable length from Ethernet network source to the
terminal does not exceed 100 meters (330 feet). The PoE is not a
repeater and does not amplify the Ethernet data signal.
•
Use a splitter if desired; ensure that the splitter is connected close to
the terminal and not on the PoE Injector.
•
No “on
-
off” switch exists; simply plug the PoE Injector into an AC
power source.
Installing the Unit:
•
Connect the PoE Injector to an AC outlet (100-240VAC), using a
standard power cord.
•
Connect the Data IN jack (input) to the remote Ethernet network
switch’s Patch panel and the PoE OUT jack (output) to the terminal.
5.
Troubleshooting
PoE Injector dos not power up:
•
Verify that a reliable power cord is used.
•
Verify that the voltage at the power inlet is between 100 and 240
VAC.
•
Remove and re-apply power to the device and check the indicators
during power up sequence.
