75
3. Press the
Y / +
or
N / -
key to change the Channel up or down. At each
channel the display will show
“hit Find”
to search for a Duplex Group name
operating on that channel.
4. When the DT402D discovers a Duplex Group the name will blink in the
display. In the example below, the Group Name is the default (Dtx0048)
for a UR92 that has been installed in another system.
5. Press the
eNTeR
key to join the Group and then select the loco address
you want to run on the layout. You are now ready to run your train.
14.4.2 Configuring the Duplex Group name
The UR92 ships from the factory with a default Duplex Group name of
“Dtxnnnn”
, where
nnnn
is the serial number. It is easily changed using the fol-
lowing steps:
1. Plug a DT402D throttle into the UR92.
2. Press the
eXIT
key.
3. Press the
OPT / t
key then the
eDIT
key.
4. Turn the
L
Throttle
knob to position the cursor. The character will blink to
show it has been selected.
5. Turn the
R
Throttle
knob to choose the character. The character will con-
tinue to blink until you move to the next position or press the
eNTeR
key.
6. Repeat steps 3 and 4 until desired name is obtained.
7. Press the
eNTeR
key to change the Duplex Group name. DT402D throt-
tles will need to rejoin on the new Group name.
