68
13.3 Controlling Functions 20-28
1. While holding the
FUNC
key down, press the 2 Key then release both
keys simultaneously. The throttle will go into the ‘+20’ mode and display
will show the following:
2. Select the second digit from the throttle’s numeric keypad and you’re done.
Example:
So if you want to turn on function 27, just hold the
FUNC
key
down while pressing the
2
key then releasing both keys simultaneously.
Next press the
7
key. That’s it. You’ve just turned function 27 on.
3. Press the
FUNC
key once to exit the ‘+20’ function mode and return to the
normal single digit function address mode. Note that you will have to
return to the ‘+20’ mode to check whether any functions in the +20 range
are active.
13.4 Controlling Functions On Consisted Locomotives
Even though an individual locomotive is part of a consist and you can’t control
its speed and direction separately from the consist, you can still control its
function outputs independently as follows:
1. Press the
LOCO
key and select the address of the locomotive that is a part
of a consist for which you want to control functions.
2. Press the
LOCO
key again to select the loco address on your throttle. The
speed value will show
“cn”
to remind you that you can only control func-
tions on the loco and not its speed.
3. Use the steps described in Controlling Functions Sections 13.1 through
13.3 to turn on or off the functions on the consisted loco.
