55
10.4.6 Y / + and N / - keys
Y / +
key and
N / -
key are used:
to turn track power on and off,
to increase or decrease loco speed.
to link and unlink locos during MU’ing.
to accomplish tasks using system editors.
These keys can be set up to act in two different ways:
Repeating
(also called typematic) so that if you hold a key down it will
continue to increase or decrease step by step until you release the
key. This option is active when your throttle is set up for ballistic
tracking. Your DT402 was shipped from the factory with this fea-
ture enabled.
Single Press
so that you will must press the key each time you want to
increase or decrease. This option is active when your throttle is set
up for straight line tracking.
See Section 16.0 (option:
NoBlstic
) for information on changing this
setting on your DT402.
10.4.7 DISP key
The
DISP
key is used for displaying programming information and dis-
patching loco addresses.
10.4.8 PROG key
The
PROG
key is used to enter programming mode and to toggle among
the programming modes available for use.
10.4.9 eDIT key
The
eDIT
key is used to enter the Edit Mode for editing the fast clock,
routes, signaling, etc. It is also used to status edit decoders while in loco-
motive address selection mode.
10.4.10 FIND key
The
FIND
key is used in conjunction with a layout instrumented for
Digitrax Transponding and locos or cars equipped with transponders to
find the location of those pieces of rolling stock on the layout.
10.4.11 BACk key
The
BACk
key is used to go back one step.
Y
Y
++
N
DISP
DISP
PROG
PROG
EDIT
EDIT
FIND
FIND
BACK
BACK
