MAKING CONNECTIONS / APPLYING POWER
BYPASSING EFFECTS & USING THE TUNER
WHAT’S IN THE BOX
•
BP355 Bass Multi-Effects Processor & USB Recording Interface
•
Power Supply
REGISTER YOUR PRODUCT
To activate your warranty, please register at
http://digitech.com/en-US/support/warranty_registration.
GET X-EDIT
To get the X-Edit software, visit
http://digitech.com/en-US/products/bp355#downloads.
GET THE OWNER’S MANUAL
Scan the QR code to get the owner’s manual or visit
http://digitech.com/en-US/products/bp355#documentation.
1
2
Live Application
Recording / Practice Application
A. Set your bass amp(s) to a clean tone, set
the tone controls for a flat EQ response
(on most amps, this would be 0 or 5
on the tone controls), turn the volume
control(s) all the way down, then power
off the amp(s). If connecting to a mixer,
fully lower the corresponding channel
fader(s).
B. Make connections as shown in the
diagrams to the right, depending on
application type.
C. Connect the included power supply to
the POWER input jack and plug it into
an available AC outlet.
D. Set the BP355’s MASTER LEVEL control
to 75.
E. Power on your bass amp(s). slowly
raise the amp volume control(s) for the
desired volume. If using a mixer, adjust
each channel’s gain/trim and fader
controls for the desired volume.
A. To bypass effects, press the UP and DOWN
footswitches simultaneously. The display
will read “BYPASS”.
B. To exit Bypass mode, press any footswitch.
C. To use the Tuner, press and hold the UP
and DOWN footswitches simultaneously
for 2 seconds. The display will briefly read
“TUNER” then enter Tuner mode.
D. Play a note on the bass. The note will be
shown in the display and the LEDs on the
left will indicate if the note is sharp, flat, or
in tune.
E. To exit Tuner mode, press any footswitch.
E
Press for Bypass, hold for Tuner
Sharp
Flat
In Tune
