page 67
Digital Projection E-Vision Laser 4K Series
Operating Guide
USING THE PROJECTOR
Rev A June 2017
Setup menu continued from previous page
OSD Settings
•
Language
sets the OSD language.
•
Menu Position
determines where the OSD should appear on the screen when
activated.
•
Menu Transparency
sets OSD transparency between
0%
(no transparency),
25%
,
50%
and
75%
.
•
Time Out
determines how long the OSD should remain on screen if no buttons are
pressed. Choose
Always On
to disable this feature.
•
Message Box
determines whether projector status messages should appear on the
screen.
Memory
The current image settings can be saved as a preset, which you can recall later. The
default settings can be recalled at any time as well.
Up to four custom presets can be stored for each input.
The following settings are saved in a preset:
•
From the
Image
menu — Dynamic Black, Smooth Picture,
Gamma
,
Brightness
,
Contrast
,
Saturation
,
Hue
,
Sharpness
and
Noise Reduction
•
From the
Color
menu —
Color Space
,
Color Mode
,
ColorMax
,
Color Temperature
,
Dynamic Black
,
RGB Lift
and
RGB Gain
•
From the
Geometry
menu —
Aspect Ratio
and
Overscan
To recall a saved preset:
•
Select
Recall Memory
and press
ENTER/OK
, then select a preset from
Preset A
to
Preset D
. Select
Default
to load factory default values.
To save a preset:
•
Select
Save Settings
and press
ENTER/OK
, then choose from
Preset A
,
Preset B
,
Preset C
and
Preset D
.
Notes
Presets from one input cannot be
applied to another input.
Presets for inputs HDMI 3 and 4 do
not contain all the settings normally
stored for other inputs.
OSD Settings
Menu Position
Menu Transparency
Language
Time Out
Message Box
Center
0
English
30 Seconds
On
Memory
Save Settings
Recall Memory
Preset A
Default
