Digital Equipment RapidPrint 500, Reference Manual

Page: 122 / 192

Crash 451 Command Reference
11 - 4
11.5 Crash 451
Immediately reboots the server. All users are logged off and sessions are disconnected. If upline
dumping is enabled, the server generates a dump file on the VMS load host before rebooting.
Restrictions You must be the privileged user to use this command.
See Also Initialize Server ; Rebooting the RapidPrint 500 .
11.6 Define
Define is equivalent to Set, but Define changes the permanent characteristics of ports, servers, and
services. Define Port settings do not take effect until after the current user logs out. Define Server
and Define Service settings remain unchanged until the server is rebooted. To make a permanent
change that takes effect immediately, you must enter both a Define and a Set command with the
same parameters. All Define commands are documented together with their corresponding Set
commands later in this chapter.
11.7 Finger
This command is an implementation of the UNIX Finger command that shows local and remote
users. The finger command by itself will show the ports on the RapidPrint 500.
Errors
An error is displayed if the host cannot be accessed.
Parameters username
Shows information about user username on the RapidPrint 500.
username@host
Shows information regarding user username on TCP/IP host host.
@host
Shows all users currently connected to TCP/IP host host.
NOTE:
To see a list of processes running on the RapidPrint 500, use the command “finger
finger.”
Examples
Local> FINGER
Local> FINGER bob
Local> FINGER @hydra
Local> FINGER bob@hydra
Local> FINGER FINGER
See Also
Show/Monitor Users .
CRASH 451
FINGER username
[ ]
@host
[ ] [ ]