Digital Equipment Pro-Face PL-6700 43 Series, User Manual

Page: 43 / 97

PL-6700 43 Series User’s Manual 3-12
Chapter 3 -
Installing Optional Units and
Expansion Boards
6) Connect the PL-SA100’s additional
DC power cable to the DC OUT
connector.
5) Thread the PL-SA100 connection
cable’s PL-HD100 cable conector
through the slot shown here and up
through to the top of the chassis.
Then, connect the cable’s middle
connector to the main board’s
HDD connector.
• Be sure to connect the CD-
ROM drive connector cable’s
#1 pin mark side with the IDE
interface’s #1 pin.
DC Power Cable
Connect to
DC Input
Connect to
CD-ROM
drive
C o n n e c t t o
PL-HD100
DC Out
Connector
Middle Connector
(Insert into main board’s
HDD connector)
PL-SA100
I n s e r t t h e P L -
HD100 connec-
tor here
7) Last, connect the PL-HD100 to the
end of the cable and use the attach-
ment screws to fix the HD unit in
place.
DC Out
Connector
!!!!!
Important
3-2 Available Options and Expansion Boards
Do not use
these pins
<Figure 1 - PL-HD100 Connector>
Cable Inversion Prevention Pin (Removed)
Connect the
cable here
Caution
!!!!!
If the hard disk unit’s connector is attached incorrectly, there is a possibility of damage to the unit.
Please follow the instructions given here carefully.
X X
Be sure the hard disk unit cable’s main board connector is not skewed from its correct attachment
position (see above examples). Incorrect attachment can cause damage to the unit.