Chapter 4 – Transfer Screen Data
4-6
GLC2400/2500/2600 Series User Manual
The GLC unit allows you to transfer screen data between your PC and the GLC
and to upload internal GLC data to its CF Card using the CF Memory Loader
Tool.
•
You need to transfer the CF Memory Loader Tool to the CF
Card prior to using the CF Memory Loader Tool.
GP-PRO/PBIII for Windows Operation Manual
•
The combination of the CF Memory Loader Tool and
Backup Data often requires at least 8MB of CF Card
memory. Use Digital’s CF Card “GP077-CF20 (16MB)” or
“GP077-CF30 (32MB).”
Starting the CF Memory Loader Tool
There are two methods for starting this program via the CF Card.
1. Menu Bar: Using the GLC unit’s [CF BOOT] menu
Insert the CF Card with the CF Memory Loader Tool saved into the GLC and
touch the menu screen’s
CF BOOT
selection. The GLC will be reset, and after it
restarts, the CF card’s CF Memory Loader Tool will start.
For information about displaying the Menu bar, see Section
6.4.3
– “
SET UP TOUCH PANEL
.”
3. Next, click on the 2/3 cell to display the following menu.
4. The IP Address assigned to the GLC will appear in the menu bar.
IP Address will not be reflected unless GLC was reset or power
cord was re-connected. After changing “Ethernet Setup” set-
tings, the GLC must then be reset or power cord must be re-
connected.
4.3
CF Memory Loader Tool