4-5
Chapter 4 – Transfer Screen Data
GLC2400/2500/2600 Series User Manual
You can now transfer data from your PC’s screen creation software.
GP-PRO/PBIII for Windows Operation Manual
(included in the
screen creation software package)
Transfer the logic program data from your PC, via the Logic Program Develop-
ment Software.
For details about the Logic Program Development Software, refer to
GP-PRO/PBIII for Windows Operation Manual
(included with Pro-
Control Editor).
When transferring data using the GLC setup is completed
When you transfer screen creation software data from your PC to the GLC while
the GLC is in RUN mode, the screen will change automatically to “Ethernet
Mode.” If it does not, you will need to manually change the GLC screen to
Ethernet Mode, via the following screen.
4.2.1 Checking the IP Address
Use the following procedure to check the IP Address assigned to the GLC and
some considerations/precautions.
1. Display the menu bar. For instructions on how to display the menu bar,
6.4.3 – “SET UP TOUCH PANEL”
2. Click on the left-side 1/3 cell of the menu bar to display the next menu.