Chapter 3 – Installation and Wiring
3–14
GLC2400/2500/2600 Series User Manual
3.3
Tool Connector
A Data Transfer Cable, Memory Loader, or a Bar-Code Reader can be attached to
the GLC unit’s Tool Connector.
When the Bar Code Reader uses a separate power supply:
•
Turn the Bar Code Reader
ON
before turning the GLC
ON.
•
Turn the GLC
OFF
before turning the Bar Code Reader
OFF.
Ethernet Interface
(RJ-45 Connector)
Tool Connector
3.4
Ethernet Cable Connector
The GLC Ethernet interface is IEEE802.3 compliant, and transmits data at 10
Mbps. Your Ethernet connector can be found on the GLC, as follows.
•
It is strongly recommended that your Ethernet network is in-
stalled by a trained engineer.
•
1:1 connections using a cross cable may not be possible de-
pending on the type of personal computer and network card
you are using. Make sure to use a hub for connection.
WARNING
Rear Face
GLC-2400T
Side Face
GLC-2400T
To prevent an electrical shock, unplug the GLC unit’s
power cord from the main power supply prior to attach-
ing or detaching any connectors to or from the GLC.
Rear Face
GLC-2500T/GLC-2600T
Side Face
GLC-2500T/GLC-2600T