Digital Electronics GP-2401 Series, User Manual

Page: 22 / 139

GP-2401/2501/2601 Series User Manual 1-5
Chapter 1 - Introduction
All optional equipment listed here is produced by Digital Electronics Corporation.
*1 For detailed information about the range of connectable PLC manufacturers and
models,
GP-PRO/PBIII for Windows Device/PLC Connection Manual
Available Software
Tool Connector
Serial Interfaces
1.3 Accessories
Product Name Model No. Description
Screen Data
Transfer Cable
GPW-CB02
Connects the GP to a personal computer.
Transfers screen data and user
program(s).
Product Name Model No. Description
RS-232C cable
*1
GP410-IS00-O
GP230-IS11-O
GP230-IS12-O
(for Multi-link)
RS-422 Connector
Terminal Adapter
*1
GP070-CN10-O
Conversion adapter to convert serial data
to RS-422 format
2 Port Adapter II
GP070-MD11
Interface unit that allows use of both GP
and Mitsubishi A, Q, C and FX series
peripheral equipment.
2 Port Adapter II Cable
GP070-MDCB11 Connects the GP to 2 Port Adapter II.
Mitsubishi A Series
Programming Port I/F
cable
GP430-IP10-O
Mitsubishi FX Series
Programming Port I/F
cable
GP430-IP11-O
RS-422C cables
*1
Interface cables between the host (PLC)
and the GP.
Connects directly to Mitsubishi's PLC
Programming port. Simultaneous use of
programming console, however, is not
possible.
*1 GP-PRO/PB III for Windows under Ver.6.22 does not support the following GP units.
If you install the add-on software, the above GP units will be available.
You can download the add-on software from Pro-face's web site.
(http://www.pro-face.com/)
Ver.6.10 to Ver.6.1* Ver.6.20 to Ver.6.21
Not suported
GP units
GP-2401T
GP-2501L
GP-2601T
GP-2501L
Product Name Model No. Description
GP-PRO/PB III
C-Package02
(GP-PRO/PB III for
Windows Ver. 6.10 or
later)
GPPRO-CNT01W-P02
*1 Software to be used to create the GP's
screen data. Installed in a personal
computer.