24
EVOLUTION LX
SYSTEM MANUAL Issue 1.0 5 DEC 2009
SETTING PRINT DELAY AND LINE SPEED
LINE SPEED
– This setting adjusts the width of the printed message on the
product. This setting should be adjusted to produce the desired print on the
product. Line speed can be increased or decreased to stretch or compress the
message to fit the desired print area.
SETTING LINE SPEED
Normally, the system will be set to use the internal
time base for line speed control. The default value is
100, which creates a normal width character on a
line moving at 100 ft per min. The print can be
narrowed by increasing the number and widened by
decreasing the number. Pressing
accesses
this parameter. Once pressed, a new screen appears, as shown to the left.
Changes can now be made by using
or
. The range of values for
character width is 10 to 200. Once the desired number is chosen, press
to
save your entry.
If external encoder is enabled and the unit is in the
PRINTING mode the user has the option of
adjusting the compression ratio of the printed
message. Changes may be made by using
or
. Once the desired number is chosen, press
to save your entry.
< - - SELECT - - >
LINE SPEED = 100
< - - SELECT - - >
ENCODER DIV = 1