background image

MT-1 USER 

GUIDE

POLE  

MOUNT

MT-1-1 

 rev 1.1

The pole mount configuration allows a CS-DUO or CS-SOLO to mount on 

a microphone stand that is already being used on stage, reducing stage 

clutter and eliminating the expense of purchasing dedicated stands for 

personal mixers.

The MT-1 is compatible with pole diameters between 3/8” to 1 1/4”.  This 

allows the MT-1 to work with a wide variety of microphone, music and 

percussion stands.

Before you begin, locate these features on the MT-1:

1.  2x Threaded knobs (1 3/4” length, 1/4” - 20 thread)

2.  1x Removable V-Clamp piece

3.  2x Captive thumbscrews (thread into CS-DUO or CS-SOLO)

To attach the MT-1 and CS-DUO or CS-SOLO to your mic/music stand 

pole:

1.  Loosen the threaded knobs to the point where the V-Clamp can 

swing freely.

2.  Insert the mic/music stand pole between the V-Clamp and the back 

of the MT-1.

3.  Tighten the threaded knobs evenly until the MT-1 is fastened tightly 

to the pole.

4.  While holding the CS-DUO or CS-SOLO, slide the CS-DUO or CS-SOLO down the flat face of the 

mount so the back wall of the personal mixer catches the alignment surface of the MT-1.

5.  Still holding the CS-DUO or CS-SOLO, center it on the MT-1 and thread the thumbscrews into the 

personal mixer by hand.  If permanent attachment is desired, the thumbscrews can also accommodate 

Flathead and Phillips screwdrivers.    

6.  Route cables through cable management openings.

1266 Park Road

Chanhassen, MN 55317

952-401-7700

[email protected]

www.digitalaudio.com

Reviews: