Digital Ally, Inc.
|
Wireless Microphone Operation
5-1
DVM-800 Operation Guide
|
860-00186-00 Rev L
Section 5
Wireless Microphone Operation
The DWM Wireless Microphone can be worn on a duty belt and
uses a built in microphone or the included lapel microphone.
5.1 Syncing a Transmitter to a Receiver Cradle
Up to two microphones can be syncronized and used with a single
cradle.
1.
Verify power to the Cradle is on; turn the Transmitter power
switch to the
ON
position and the notification switch to the
BEEP
position.
2. Place the Transmitter into the Cradle. The
BATT
status
indicator on the Cradle will light RED if charging is in process
or GREEN if the unit is fully charged.
3. The
IN-USE
indicator on the front of the Cradle will light
Green for several seconds, then it will turn off. This
Transmitter and Cradle are now synchronized together. If
the Transmitter was paired to another Cradle it will no
longer respond to previous Cradle pairing.
The pairing operation only needs to be performed the first time
a system is used, or a new Transmitter is used with a Cradle
previously paired to another Transmitter.
5.2 Basic Operation
1. Remove the Transmitter from the Cradle, plug in the lapel microphone
if being used; turn the Transmitter on and place it on your belt.
2. To start the recording, press the
REC
button; the Status indicator will
light a constant green and you will hear a short Beep or Vibration
(unless in Covert mode).
3. To end a recording, press the
REC
button on the
DVM-800
. The
Transmitter cannot be used to stop a recording.
4.
At the end of your shift, turn the Transmitter off and place it in the
charging Cradle.
5.3 Using the Lapel Microphone
Your Transmitter has a built-in microphone located on the top of
the unit, adjacent to the microphone jack. However, for best audio
performance we recommend using the supplied external lapel
microphone which will reduce unwanted ambient noise.
