Digisol DG-GS4826S, Management Manual, Page: 846 / 1344

C
HAPTER
32 | Interface Commands
– 846 –
interface
This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface. Use the no form with a Layer 3 VLAN (normal type) to change it
back to a Layer 2 interface.
S
YNTAX
[ no ] interface interface
interface
ethernet unit / port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26/50)
port-channel channel-id (Range: 1-32)
vlan vlan-id (Range: 1-4093)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
To specify port 4, enter the following command:
Console(config)#interface ethernet 1/4
Console(config-if)#
alias
This command configures an alias name for the interface. Use the no form
to remove the alias name.
S
YNTAX
alias string
no alias
string - A mnemonic name to help you remember what is attached
to this interface. (Range: 1-64 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)