Digisol DG-GS4826S, Management Manual

Page: 644 / 1344

C
HAPTER
24 | General Commands
– 644 –
disable
This command returns to Normal Exec mode from privileged mode. In
normal access mode, you can only display basic information on the switch's
configuration or Ethernet statistics. To gain access to all commands, you
must use the privileged mode. See "Understanding Command Modes" on
page 632 .
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
The “>” character is appended to the end of the prompt to indicate that the
system is in normal access mode.
E
XAMPLE
Console#disable
Console>
R
ELATED
C
OMMANDS
enable (641)
reload (Privileged
Exec)
This command restarts the system.
N
OTE
:
When the system is restarted, it will always run the Power-On Self-
Test. It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
This command resets the entire system.
E
XAMPLE
This example shows how to reset the switch:
Console#reload
System will be restarted, continue <y/n>? y