Digisol DG-GS4826S, Management Manual

Page: 342 / 1344

C
HAPTER
14 | Security Measures
Filtering IP Addresses for Management Access
– 342 –
W
EB
I
NTERFACE
To display the ARP Inspection log:
1. Click Security, ARP Inspection.
2.
Select Configure Information from the Step list.
3. Select Show Log from the Step list.
Figure 182: Displaying the ARP Inspection Log
F
ILTERING
IP A
DDRESSES FOR
M
ANAGEMENT
A
CCESS
Use the Security > IP Filter page to create a list of up to 15 IP addresses or
IP address groups that are allowed management access to the switch
through the web interface, SNMP, or Telnet.
CLI R
EFERENCES
u
"Management IP Filter" on page 773
C
OMMAND
U
SAGE
u
The management interfaces are open to all IP addresses by default.
Once you add an entry to a filter list, access to that interface is
restricted to the specified addresses.
u
If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
u
IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
u
When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
u
You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.