Digisol DG-GS4826S, Management Manual

Page: 133 / 1344

C
HAPTER
4 | Basic Management Tasks
Renumbering the Stack
– 133 –
R
ENUMBERING THE
S
TACK
If the units are no longer numbered sequentially after several topology
changes or failures, use the System > Renumbering page to reset the unit
numbers. Just remember to save the new configuration settings to a
startup configuration file prior to powering off the stack Master.
CLI R
EFERENCES
u
"switch all renumber" on page 648
C
OMMAND
U
SAGE
u
The startup configuration file maps configuration settings to each
switch in the stack based on the unit identification number. You should
therefore remember to save the current configuration after
renumbering the stack.
u
For a line topology, the stack is numbered from top to bottom, with the
first unit in the stack designated at unit 1. For a ring topology, the
Master unit is taken as the top of the stack and is numbered as unit 1,
and all other units are numbered sequentially down through the ring.
W
EB
I
NTERFACE
To renumber the units in the stack:
1. Click System, then Renumber.
2.
Click OK when the confirmation message appears.
Figure 19: Renumbering the Stack