Digisol DG-GS4826S, Management Manual

Page: 1284 / 1344

C
HAPTER
49 | Multicast Routing Commands
PIM Multicast Routing
– 1284 –
E
XAMPLE
In the following example, the first PIM-SM command just specifies the RP
address 192.168.1.1 to indicate that it will be used to service all multicast
groups. The second PIM-SM command includes the multicast groups to be
serviced by the RP.
Console(config)#ip pim rp-address 192.168.1.1
Console(config)#ip pim rp-address 192.168.2.1 group-prefix 224.9.0.0
255.255.0.0
Console(config)#end
Console#show ip pim rp mapping
PIM Group-to-RP Mappings
Groups : 224.0.0.0/4
RP address : 192.168.1.1/32
Info source : static
Uptime : 00:00:33
Expire : Never
Groups : 224.9.0.0/16
RP address : 192.168.2.1/32
Info source : static
Uptime : 00:00:21
Expire : Never
Console#
ip pim rp-candidate
This command configures the router to advertise itself as a Rendezvous
Point (RP) candidate to the bootstrap router (BSR). Use the no form to
remove this router as an RP candidate.
S
YNTAX
ip pim rp-candidate interface vlan vlan-id
group-prefix group-address mask
[ interval seconds ] [ priority value ]
no ip pim rp-candidate interface interface vlan vlan-id
vlan-id - VLAN ID (Range: 1-4094)
group-address - An IP multicast group address.
mask - Subnet mask that is used for the group address.
seconds - The interval at which this device advertises itself as an RP
candidate. (Range: 60-16383 seconds)
value - Priority used by the candidate RP in the election process.
The RP candidate with the largest priority is preferred. If the priority
values are the same, the candidate with the larger IP address is
elected to be the RP. Setting the priority to zero means that this
router is not eligible to server as the RP. (Range: 0-255)
D
EFAULT
S
ETTING
Interval: 60 seconds
Priority: 0