Digisol DG-GS1550, Management Manual

Page: 305 / 665

Entering Commands
4-5
4
The command “ show interfaces ? ” will display the following information:
Show commands which display more than one page of information (e.g., show
running-config ) pause and require you to press the [Space] bar to continue
displaying one more page, the [Enter] key to display one more line, or the [a] key to
display the rest of the information without stopping. You can press any other key to
terminate the display.
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match the
initial letters are provided. (Remember not to leave a space between the command
and question mark.) For example “
s? ” shows all the keywords starting with “s.”
Negating the Effect of Commands
For many configuration commands you can enter the prefix keyword “ no ” to cancel
the effect of a command or reset the configuration to the default value. For example,
the
logging command will log system messages to a host server. To disable
logging, specify the no logging command. This guide describes the negation effect
for all applicable commands.
Using Command History
The CLI maintains a history of commands that have been entered. You can scroll
back through the history of commands by pressing the up arrow key. Any command
displayed in the history list can be executed again, or first modified and then
executed.
Using the show history command displays a longer list of recently executed
commands.
voice Shows the voice VLAN information
Console#show
Console#show interfaces ?
brief brief interface description
counters Interface counters information
protocol-vlan Protocol-VLAN information
status Interface status information
switchport Interface switchport information
Console#show interfaces
Console#show s?
snmp sntp spanning-tree ssh startup-config
system
Console#show s