Digisol DG-FS4528P, Management Manual

Page: 837 / 973

C
HAPTER
39 | VLAN Commands
Configuring Voice VLANs
– 837 –
C
OMMAND
U
SAGE
Specifies a CoS priority to apply to the port VoIP traffic on the Voice VLAN.
The priority of any received VoIP packet is overwritten with the new
priority when the Voice VLAN feature is active for the port.
E
XAMPLE
The following example sets the CoS priority to 5 on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan priority 5
Console(config-if)#
switchport voice
vlan rule
This command selects a method for detecting VoIP traffic on a port. Use
the no form to disable the detection method on the port.
S
YNTAX
[ no ] switchport voice vlan rule { oui | lldp }
oui - Traffic from VoIP devices is detected by the Organizationally
Unique Identifier (OUI) of the source MAC address.
lldp - Uses LLDP to discover VoIP devices attached to the port.
D
EFAULT
S
ETTING
OUI: Enabled
LLDP: Disabled
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
When OUI is selected, be sure to configure the MAC address ranges in
the Telephony OUI list (see the voice vlan mac-address command. MAC
address OUI numbers must be configured in the Telephony OUI list so
that the switch recognizes the traffic as being from a VoIP device.
LLDP checks that the “telephone bit” in the system capability TLV is
turned on. See "LLDP Commands" on page 898 for more information on
LLDP.
E
XAMPLE
The following example enables the OUI method on port 1 for detecting
VoIP traffic.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan rule oui
Console(config-if)#