Digisol DG-FS4528P, Management Manual

Page: 818 / 973

C
HAPTER
39 | VLAN Commands
Configuring Port-based Traffic Segmentation
– 818 –
interface-list – One or more uplink or downlink interfaces.
ethernet unit / port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-8)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
A port cannot be configured in both an uplink and downlink list.
A port can only be assigned to one traffic-segmentation session.
A downlink port can only communicate with an uplink port in the same
session. Therefore, if an uplink port is not configured for a session, the
assigned downlink ports will not be able to communicate with any other
ports.
If a downlink port is not configured for the session, the assigned uplink
ports will operate as normal ports.
Due to switch ASIC limitations, ports 1-8, 9-16, 17-24 on the DG-
FS4528P are grouped together when any group member is configured
as an uplink or downlink interface.
E
XAMPLE
Console(config)#pvlan session 1 uplink ethernet 1/25 downlink ethernet 1/1
Console(config)#
pvlan session
This command creates a traffic-segmentation client session. Use the no
form to remove a client session.
S
YNTAX
[ no ] pvlan session session-id
session-id – Traffic segmentation session. (Range: 1-15)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration