Digisol DG-FS4528P, Management Manual

Page: 582 / 973

C
HAPTER
25 | Authentication Commands
802.1X Port Authentication
– 582 –
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#
dot1x max-req
This command sets the maximum number of times the switch port will
retransmit an EAP request/identity packet to the client before it times out
the authentication session. Use the no form to restore the default.
S
YNTAX
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
D
EFAULT
2
C
OMMAND
M
ODE
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#
dot1x operation-
mode
This command allows hosts (clients) to connect to an 802.1X-authorized
port. Use the no form with no keywords to restore the default to single
host. Use the no form with the multi-host max-count keywords to
restore the default maximum count.
S
YNTAX
dot1x operation-mode { single-host |
multi-host [ max-count count ] | mac-based-auth }
no dot1x operation-mode [ multi-host max-count ]
single-host – Allows only a single host to connect to this port.
multi-host – Allows multiple host to connect to this port.
max-count – Keyword for the maximum number of hosts.
count – The maximum number of hosts that can connect to a
port. (Range: 1-1024; Default: 5)
mac-based – Allows multiple hosts to connect to this port, with
each host needing to be authenticated.