Digisol DG-FS4528P, Management Manual

Page: 337 / 973

C
HAPTER
13 | VLAN Configuration
Traffic Segmentation
– 337 –
Uplink-to-Uplink – Specifies whether or not traffic can be forwarded
between uplink ports assigned to different client sessions.
(Default: Blocking)
W
EB
I
NTERFACE
To enable traffic segmentation:
1. Click VLAN, Traffic Segmentation, Status.
2. Set the traffic segmentation status or uplink-to-uplink forwarding
mode.
3. Click Apply.
Figure 165: Configuring Global Settings for Traffic Segmentation
C
ONFIGURING
U
PLINK
AND
D
OWNLINK
P
ORTS
Use the VLAN > Traffic Segmentation > Session Configuration page to
create a client session, and assign to service the traffic associated with
each session. Ports designated as downlink ports can not communicate
with any other ports on the switch except for the uplink ports. Uplink ports
can communicate with any other ports on the switch and with any
designated downlink ports.
CLI R
EFERENCES
"Configuring Port-based Traffic Segmentation" on page 816
P
ARAMETERS
These parameters are displayed:
Session ID – Traffic segmentation session. (Range: 1-15)
Direction – Adds an interface to the segmented group by setting the
direction to uplink or downlink. (Default: None)
Interface – Displays a list of ports or trunks.
Port – Port Identifier. (Range: 1-28)
Trunk – Trunk Identifier. (Range: 1-8)