Digisol DG-FS4528P, Management Manual

Page: 256 / 973

C
HAPTER
8 | Interface Configuration
Trunk Configuration
– 256 –
3.
Click Apply.
Figure 114: Enabling LACP on a Port
C
ONFIGURING
P
ARAMETERS FOR
LACP G
ROUP
M
EMBERS
Use the Port > LACP > Dynamic Aggregation Port page to set the
administrative key for a group member, and configure protocol parameters
for local and partner ports.
CLI R
EFERENCES
"Link Aggregation Commands" on page 690
C
OMMAND
U
SAGE
Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
Ports must have the same LACP System Priority.
Ports must have the same LACP port Admin Key.
Ports are only allowed to join the same Link Aggregation Group (LAG) if
(1) the LACP port system priority matches, (2) the LACP port admin key
matches, and (3) the LAG admin key matches (if configured). However,
if the LAG admin key is set, then the port admin key must be set to the
same value for a port to be allowed to join that group.
N
OTE
:
If the LAG admin key is not set when a channel group is formed (i.e.,
it has a null value of 0), the operational value of this key is set to the same
value as the port admin key used by the interfaces that joined the group.